Alaloth Champions Of The Four Kingdoms Multiplayer, Speed Of Computer Is Measured In Nanoseconds, Articles OTHER

Wilson just got that particular stainless perfect for its purpose. Mags were 3 new wilson combat 7 rd and 1 DW 7 rd. If youre interested in some other perspectives, check out Range Hot and/or Gunbelts.com. Failure to feed issues with my new PT1911 - Taurus Firearm Forum He greatly thought the hammer end of the extractor was too large, the tunnel too small, or the tunnel out of round. Nosedive And Feed Angle In The 1911 .45 ACP Tokarev 33 feed good lips magazine nyet pistol machined lips, not to kiss dah. No shit. That might be the wax on cheap bulk-pack .22lr. Last round failure to feed At my last two practice sessions I have noticed that my Colt 1991 has started failing to feed the last round in the magazine. When I took it out of the box, I cleaned and lubed it, didn't notice anything wrong. 3 inch is cycling too fast to pick up the last round because the force on the last round in the mag is lower. The last thing to check is if the bullet is out of spec. And if you heat the lips to bend them, then youve changed the temper and the mag will never be the same again. I even sent the pistol into Colt to be repaired. Either last week or the week before I found a 22lr (unfired) that had a green plastic looking coating on the bullet. These days, youre likely to find him shooting something a bit more modern and usually equipped with a suppressor but his passion for firearms with military heritage has never waned. Using such an alloy for mags makes sense because theyre unlikely to have a problem where theyre brittle enough for it to matter and theyre hard enough that things like feed lips wont bend the way carbon steel would under the same conditions. TRP has +6k! The round would be resting atop the magazine and appeared to be at an upward angle with the tip of the bullet touching in the vicinity of the top edge of the frame ramp. Greg K. Aint no 9mm rounds have wax on them. If the feed lips are in spec changing the spring is the first thing I would try. Gunsmithing, Troubleshooting & Refinishing, If this is your first visit, be sure to I like to see .010-.012 inch with a maximum of .015 inch, or about a 64th. I suspected several probable causes: feed ramp, ammo or magazine.Credit goes to Mr. Ernie Claudio (the 1911 doctor) for helping discover the cause of the feeding problem.Shout out to Chip McCormick magazines! I havent seen that perfect of a combination in any other mag. Whenever you experience a failure to feed or return to battery, look for horses instead of Zebras. 1911 Failure to Feed | Northeastshooters.com Forums This one is sneaky. But I'm fine with 17/20 rounds. Failure to Feed: Nosediving - YouTube When he isnt shooting or writing, Nathan nerds out over computers, 3D printing, and Star Wars. . Id say the overall keeper rate beyond 12 months is around 50%. In each case the round was just laying on top of the mag with 2 ftrtb and 2 slide stop engaged. But I just bought it! or Its never been a problem before! or I dont need to spend those big dollars on those fancy-pants magazines! and on and on.